Preparation Before Trial Operation

After passing the geometric accuracy inspection of the machine tool, it is necessary to clean the entire machine. Use cotton or silk cloth soaked in cleaning agents, and do not use cotton or gauze. Clean the rust resistant oil or paint that was applied to protect the guide rail surface and machining surface of the machine tool at the factory. Clean the dust on the external surface of the machine tool. Apply lubricating oil as specified by the machine tool to each sliding surface and working surface.
Carefully check whether all parts of the machine tool have been oiled as required, and whether there is sufficient coolant in the cooling box. Whether the oil in the hydraulic station and automatic lubrication device of the machine tool reaches the specified position on the oil level indicator.
Check whether all switches and components in the electrical control box are normal, and whether all plug-in integrated circuit boards are in place.
Start the centralized lubrication installation by powering on, so that all lubrication parts and lubricating oil circuits are filled with lubricating oil. Make all preparations before the operation of each component of the machine tool.